Home Blog


Toilet Repair – Obtaining Plumbing Working

You hear the noise of running water in the restroom, which means that you go and investigate

Little Johnny is playing with vessels, there is water everywhere and he looks at you with huge eyes and says “I had been playing whirl pool” Plumbers can be quite expensive but so is the water bill.  What exactly are you going to do?  Do not call the plumber yet.  In only a few actions you’ll be able to repair that toilet yourself.  All you need are a few tools, a little knowledge and a fantastic sense of humor.  After all it is already broken so that you can’t hurt it any more appropriate?

Initial step is a no brainer – you need to get that water turned away

Down near the ground supporting the bowl you need to observe a valve that resembles the one to your hose out simply turn it along with the water must shut off.  Now it is time to remove some of their water.  A wet vacuum will do the trick, but if you do not have a little cup will do for bail out.  Get as much out as possible. Get much more to know by visiting on this site – JPG Plumbing.

Put your hand inside the toilet and feel around if you are fortunate you will have the ability to touch the tiny toy or toilet brush or anything is holding up things in there.  If you can reach it good – just pull it out.  Turn the water back on and go on with your day knowing you saved some cash.

If you cannot feel the clog, then this is where things get tricky

You will need to unbolt the toilet and transfer it out of the way. These upcoming steps will help you through removal and replacement of the bowl.  Go to the local hardware store and get a wax ring.  You may need it and they’re usually under $5.00.  While there you might also wish to get a pipe wrench or a set of large channel locks since most toilet bolts are inch and those cute little ones in your family tool kit with all the pink grips will not do the job.

Armed and ready for battle

On both sides of the bowl on the ground you will see 2 big bolt on both sides.  Switch them counter clockwise to remove.  If you are lucky they’ll come right off.  Lift the bowl off the ground you might want to rock it a bit since the wax ring will be sticky.  Reach in and remove the toy that has caused all this trouble.  You did this!  It was not so hard was it?  The upcoming steps will help you through reinstalling the toilet.  After all, the objective is to get a fully functioning unit without the mess.

You’ll need to remove the old wax ring

This is essential as without a fantastic seal you may have leaks.  Use a scraper for it.  Or even a cake knife will do – whatever level.  Carefully remove the wax ring from the package and set it where the old one has been.  This ought to be easy since there is still some residue left behind.  Lift toilet up and quite carefully (no sliding) put it down on the bolts sticking up through the ground and onto the new ring.  Be careful here – the seal must be good.  Tighten the bolts back up.  Alternate bolts as you flip to guarantee a tight even seal.  Turn the water back on.  Look carefully around the bottom of the bowl across the ground for escapes.  If there aren’t any escapes, you can celebrate!  You have now completed a toilet repair job!